After assembling the plate to the bike. Hold the wires at the end and slip the PVC wire cover into the back plate as far as it will go. NOTE: The PVC wire covering is a tight fit in the hole on the back plate. Use a dab of silicone sealer or super glue at the insertion to assure the covering will not pull from the back plate.

Route the wire cable to the point in the picture on the right. Use the TY - Wraps supplied with the kit to anchor the wire cable to the swing arm.

  Match the wire colors and crimp the connectors as shown. The black wire must go to the frame ground for the LED's to work properly.

  Questions or problems? Contact gary@turbovmax.com

VMAX LICENSE PLATE INSTRUCTIONS